GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
c. Remove the nut, 4 screws and bracket.
d. Remove the 2 screws and ECU.
e. Raise the lock lever and disconnect the 2 connectors. Remove the hybrid vehicle control ECU.
NOTE: Make sure that the lock lever is raised 90° as shown in the illustration before disconnecting the connectors. Failure to do this may
cause the connectors to break.
7. REMOVE ECM
a. Remove the 2 nuts and ECM with bracket.
b. Disconnect the 2 ECM connectors.
1. Raise the 2 levers while pushing the locks on the 2 levers, and remove the 2 ECM connectors.