GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
b. Remove the bolt, 2 nuts and injector driver.
NOTE: Be careful not to drop or strike the injector driver.
INSTALLATION
1. INSTALL INJECTOR DRIVER
NOTE:
-
Be careful not to drop or strike the injector driver.
-
The injector driver is grounded at the bolt and nut. To ensure that it is grounded, clean all oil and foreign matter from the installation areas of
the injector driver and engine before installing the injector driver.
a. Install the injector driver with the bolt and 2 nuts.
Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)
b. Connect the 4 injector driver connectors.
1. Connect the 3 connectors with wire harness locks and the connector to the injector driver. Move the lock lever in the direction indicated by
the arrow to lock the connector.
NOTE: Connect the connector securely.