GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
c. Using SST, remove the sensor from the front exhaust pipe.
SST 09224-00010
INSTALLATION
1. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
a. Using SST, install the sensor to the front exhaust pipe.
SST 09224-00010
Torque:
40 N.m (408 kgf.cm, 30 ft.lbf) for use with SST
44 N.m (449 kgf.cm, 32 ft.lbf) for use without SST
HINT:
-
Use a torque wrench with a fulcrum length of 300 mm (11.81 in).
-
Make sure SST and wrench are connected in a straight line.
b. Pass the sensor connector through the floor panel and install the grommet.
c. Connect the sensor connector.
2. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)