GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
complicated.
d. Install SST (holder with injector seal) to the tip of the injector. Slide the seal downward into the injector groove (injector connector side) with
your fingers, as shown in the illustration.
SST 09260-39015 (09268-03010, 09268-03020)
HINT: Check that the seal covers the circumference of the injector groove as shown in the illustration.
e. Using SST (holder), gently press downward on the injector seal (injector connector side). Then slowly slide SST (guide) towards the injector
tip to settle the seal into the injector groove.
SST 09260-39015 (09268-03010, 09268-03020)
NOTE: Be careful that the seal is not pinched between SST (guide) and the injector groove. Replace the seal if it becomes damaged.
HINT:
-
When using SST (guide) to settle the seal into the groove, SST (guide) only needs to be slid upward to the position labeled A in the
illustration.