GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
SST 09260-39015 (09268-03020)
NOTE: Be careful that the seal is not pinched between SST (guide) and the injector groove. Replace the seal if it becomes damaged.
HINT:
-
Set SST (guide) so that its bottom surface and seal are flush.
-
If it is difficult to slide SST upward, slowly wiggle it from side to side while sliding it up the injector little by little.
i.
Using SST (holder), gently press downward on the injector seal (injector tip side). Then slowly slide SST (guide) towards the injector tip to
settle the seal into the injector groove.
SST 09260-39015 (09268-03010, 09268-03020)
NOTE: Be careful that the seal is not pinched between SST (guide) and the injector groove. Replace the seal if it becomes damaged.
j.
Slowly slide SST (guide) towards the tip of the injector. When the injector contact surface of SST (guide) aligns with the seal (injector tip
side) as shown in the illustration, hold the position for 5 seconds or more to fully align the seal into the injector groove.