GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
Sunroof / Moonroof Module: All Technical Service Bulletins
Body Power Sliding Roof Initialization Procedure
PRE-DELIVERY SERVICE
PD013-06
Title:
INITIALIZATION OF SLIDING ROOF
DURING PDS
Models
'07 GS 450h
March 3, 2006
Introduction
Initialize the sliding roof after installing the DCC fuse in its original location during Pre-Delivery Service (PDS).
The installation of the DCC fuse, and the initialization procedure shown below, will enable the operation of the "one-touch slide open and close"
"one-touch tilt up and down," and "jam protection" functions of the sliding roof.
NOTE:
Any time the battery terminal has been disconnected, the sliding roof must be re-initialized.
Applicable Vehicles
^
2007 model year GS 450h vehicles.
Warranty Information
Initialization Procedure
1.
Without depressing the brake pedal, push the engine START/STOP switch twice to select the "IG-ON" mode.
2.
Push and hold the sliding roof switch to the "UP" side or the "CLOSE" side until the following cycle of the sliding roof operation is completed: