GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
2. Move SST at least 10 m (33 ft.) away from the vehicle rear side window.
3. Maintaining enough clearance for the SST wire harness in the rear side window, close all doors and windows of the vehicle.
NOTE: Take care not to damage the SST wire harness.
4. Connect the red clip of SST to the battery positive (+) terminal and the black clip of SST to the battery negative (-) terminal.
g. Deploy the airbag.
1. Check that no one is inside the vehicle or within a 10 m (33 ft.) radius of the vehicle.
2. Press the SST activation switch and deploy the airbag.
CAUTION:
-
When deploying the airbag, make sure that no one is near the vehicle.
-
The rear seat side airbag becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after
deployment.
-
Use gloves and safety glasses when handling a rear seat side airbag with a deployed airbag.
-
Do not apply water to a rear seat side airbag with a deployed airbag.
-
Always wash your hands with water after completing the operation.
HINT: The airbag is deployed as the LED of the SST activation switch comes on.
2. DISPOSE OF REAR SEAT SIDE AIRBAG ASSEMBLY (WHEN NOT INSTALLED IN VEHICLE)
NOTE: Be sure to follow the procedure detailed below when deploying the airbag.
HINT: Prepare a battery as the power source to deploy the airbag.
a. Check the function of SST.
b. Remove the rear seat side airbag.
CAUTION:
-
When removing the rear seat side airbag, work must be started 90 seconds after the power switch is turned OFF and the negative
(-) terminal cable is disconnected from the battery.
-
When storing the rear seat side airbag, keep the airbag deployment side facing upward.