GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
_hybrid/Page-1733002.png)
3. REMOVE SEAT POSITION SENSOR
a. Using a T30 "TORX" socket wrench, remove the "TORX" screw and seat position sensor with sensor protector.
b. Disconnect the connector.
c. Remove the seat slide position sensor protector from the seat position sensor.
INSTALLATION
1. INSTALL SEAT POSITION SENSOR
a. Check that the power switch is OFF.
b. Check that the cable is disconnected from the battery negative (-) terminal.
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat
belt pretensioner activation.
