GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
Repairs and Inspections Required After a Collision: Service and Repair
Component Inspections
Center Airbag Sensor Assembly
ON-VEHICLE INSPECTION
1. INSPECT CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)
a. Perform a diagnostic system check.
2. INSPECT CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
a. Perform a diagnostic system check.
3. INSPECT CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED)
a. Replace the center airbag sensor.
CAUTION: For removal and installation procedures of the front airbag sensor, be sure to follow the correct procedure.
HINT: The center airbag sensor should be replaced after any of the airbags has deployed, as it has been subjected to the impact.
Curtain Shield Airbag Assembly
ON-VEHICLE INSPECTION
1. INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)
a. Perform a diagnostic system check.
b. With the curtain shield airbag installed on the vehicle, perform a visual check. If any of the defects mentioned below are present, replace the
curtain shield airbag with a new one:
Cuts, minute cracks or marked discoloration on the curtain shield airbag.
2. INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
a. Perform a diagnostic system check .
b. With the curtain shield airbag removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the
curtain shield airbag with a new one:
-
Cuts, minute cracks or marked discoloration on the curtain shield airbag.
-
Cracks or other damage to the connectors.
CAUTION: For removal and installation procedures of the curtain shield airbag, be sure to follow the correct procedure.
Front Airbag Sensor
ON-VEHICLE INSPECTION