GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
_hybrid/Page-189002.png)
c. Using SST and 2 bolts (90101-12007), remove the sensor from the hub and bearing.
SST 09520-00031 (09520-00040), 09521-00020, 09950-00020
NOTE:
-
Keep the sensor away from magnets.
-
Pull the sensor off straight, taking care not to make contact with the sensor rotor.
-
If the sensor rotor is damaged or deformed, replace the hub and bearing assembly.
-
Do not scratch the area where the sensor contacts the hub and bearing.
-
Do not attach foreign matter to the sensor rotor.
INSTALLATION
HINT:
-
Use the same procedures for the LH side and RH side.
-
The procedures listed below are for the LH side.
CAUTION: When the brake caliper is removed from the brake disc, do not start the hybrid system. If the hybrid system is started, the brake
fluid pressure may increase.
1. INSTALL FRONT SPEED SENSOR LH
a. Wipe off sealant attached to the sensor's fitting surface with non-residue solvent.
NOTE: Prevent foreign matter from attaching to the sensor rotor.
b. Install a new sensor to the hub and bearing. The sensor connector should be placed in the upper position.
