GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
a. Using SST, install the sensor to the front exhaust pipe.
SST 09224-00010
Torque:
40 N.m (408 kgf.cm, 30 ft.lbf) for use with SST
44 N.m (449 kgf.cm, 32 ft.lbf) for not use without SST
HINT:
-
Use a torque wrench with a fulcrum length of 300 mm (11.81 in).
-
Make sure SST and wrench are connected in a straight line.
b. Pass the sensor connector through the floor panel and install the grommet.
c. Connect the sensor connector.
3. INSTALL INSTRUMENT PANEL FINISH PANEL END LH
4. INSTALL INSTRUMENT PANEL FINISH PANEL END RH
5. INSTALL CONSOLE BOX PLATE
6. INSTALL CONSOLE UPPER PANEL ASSEMBLY
7. INSTALL FRONT CONSOLE UPPER GARNISH
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9. INSTALL SERVICE PLUG GRIP
10. PERFORM INITIALIZATION
a. Perform initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.