GS 450h V6-35L Hybrid Ignition Switch Diagram - Page 1313
-
The 5 given questions are important points in the problem analysis.
(2006/02- 2006/07)
DIAGNOSTIC TROUBLE CODE CHART
Look for output Diagnostic Trouble Codes (DTCs) (from the DTC checks) in the appropriate section's Diagnostic Trouble Code Chart. Use the chart to
determine the trouble area and the proper inspection procedure. A description of each of the chart's columns shown in the table.
(2006/07- )
DIAGNOSTIC TROUBLE CODE CHART
Look for output Diagnostic Trouble Codes (DTCs) (from the DTC checks) in the appropriate section's Diagnostic Trouble Code Chart. Use the chart to
determine the trouble area and the proper inspection procedure. A description of each of the chart's columns is given.
Basic Inspection
BASIC INSPECTION
a. WHEN MEASURING RESISTANCE OF ELECTRONIC PARTS
1. Unless otherwise stated, all resistance measurements should be made at an ambient temperature of 20°C (68°F). Resistance measurements may
be inaccurate if measured at high temperatures, i.e. immediately after the vehicle has been running. Measurements should be made after the
engine has cooled down.