GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
5. Perform the zero point calibration by following the prompts on the tester screen.
HINT:
-
Refer to the intelligent tester operator's manual for further details.
-
If the zero point calibration is performed when the calibration conditions are not satisfied, DTC B1797 is output.
-
If the zero point calibration has failed, DTC B1797 is output.
2. SENSITIVITY CHECK
a. Sensitivity check procedures
1. Turn the power switch OFF.
2. Place a weight of 20 kg (44.0 lb) on the front passenger seat.
NOTE:
-
Do not allow the weight to come into contact with the seatback when placing it on the seat cushion.
-
Place the weight in the area shown in the illustration.
3. Turn the power switch ON (IG), and wait for at least 6 seconds.
4. Check that the passenger airbag ON/OFF indicator indicates OFF.
OK: Passenger airbag ON/OFF indicator indicates OFF.
5. Add a weight of 30 kg (66.1 lb) to the front passenger seat (total 50 kg (110.2 lb)).
NOTE:
-
Do not allow the weight to come into contact with the seatback when placing it on the seat cushion.
-
Place the weight in the area shown in the illustration.
6. Check that the passenger airbag ON/OFF indicator indicates ON.
OK: Passenger airbag ON/OFF indicator indicates ON.
Registration
REGISTRATION
1. REGISTRATION
NOTE:
-
If any DTCs related to the occupant classification ECU are output, troubleshoot those DTCs by referring to the DIAGNOSTIC TROUBLE
CODE CHART.
-
When ECU data saving or loading operations cannot be performed, replace the front seat cushion (with occupant classification ECU and
occupant detection sensor).
HINT:
-
When the occupant classification ECU is replaced, the previous ECU data must be saved in the intelligent tester and loaded into the new ECU