GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
1. INSTALL FRONT ACTIVE STABILIZER CONTROL ECU
a. Connect the ECU connector.
HINT: Connect the connector before installing the ECU.
b. Install the ECU with the bolt and 2 nuts.
Torque:
7 N.m (71 kgf.cm, 62 in.lbf) for nut
9 N.m (92 kgf.cm, 7 in.lbf) for bolt
c. Using the procedures below, connect the ECU connectors.
1. Connect the ECU connector.
2. Rotate the lever in the direction of the arrow until a "click" sound is heard.
3. Lock the lever's lock.
d. Install the 2 ground wires to the ECU with the 2 bolts.
Torque: 10 N.m (102 kgf.cm, 7 ft.lbf)
e. Connect the wire harness clamp to the bracket.
2. INSTALL NO. 2 COOL AIR INTAKE DUCT
a. Install the intake duct with the 2 bolts.
3. INSTALL FRONT FENDER LINER RH
4. INSTALL FRONT FENDER WHEEL OPENING MOULDING RH
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. PERFORM INITIALIZATION
a. Perform initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.