GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
INSTALLATION
HINT:
^
Use the same procedures for the RH side and LH side.
^
The procedures listed below are for the LH side.
CAUTION:
When the brake caliper is removed from the brake disc, do not start the hybrid system. If the hybrid system is started, the brake fluid
pressure may increase.
1. TURN POWER SWITCH OFF
(a)
Turn the power switch OFF, and check that the "READY" indicator turns off.
2. INSTALL STEERING KNUCKLE LH
(a)
Install the steering knuckle to the upper suspension arm with a castle nut and new clip.
Torque: 87 N*m (887 kgf*cm, 64 ft.*lbf)
NOTICE:
If the holes for the clip are not aligned, tighten the nut within an additional 60°.
3. INSTALL FRONT LOWER BALL JOINT ASSEMBLY LH
(a)
Install the steering knuckle to the lower ball joint with the 2 bolts.
Torque: 120 N*m (1220 kgf*cm, 89 ft.*lbf)
4. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH
5. INSTALL FRONT DISC
6. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH
7. CONNECT FRONT SPEED SENSOR CONNECTOR LH
8. INSTALL FRONT WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
9. CHECK ABS SPEED SENSOR SIGNAL