GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
2. STABILIZE SUSPENSION
(a)
Jack up the axle carrier, with a wooden block placed between the jack and axle carrier, to apply load to the rear suspension so that the rear
drive shaft assembly becomes level.
3. TIGHTEN TOE CONTROL LINK
(a)
Tighten the nut on the rear suspension member side.
Torque: 50 N*m (510 kgf*cm, 37 ft.*lbf)
NOTICE:
Check that matchmarks on the rear suspension member and rear No. 2 suspension toe adjust plate are aligned.
(b) Install the skid control sensor wire with the bolt.
(c)
Connect the skid control sensor connector.
4. INSTALL REAR WHEEL
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
5. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
(a)
Inspect and adjust the rear wheel alignment.
6. VEHICLE PREPARATION FOR HEADLIGHT AIM ADJUSTMENT
7. HEADLIGHT AIMING ADJUSTMENT (LOW BEAM)
8. HEADLIGHT AIMING ADJUSTMENT (HIGH BEAM)