GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
Suspension Control Module: Service and Repair
Front Active Stabilizer Control ECU
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2. REMOVE FRONT FENDER WHEEL OPENING MOULDING RH
3. REMOVE FRONT FENDER LINER RH
4. REMOVE NO. 2 COOL AIR INTAKE DUCT
a. Remove the 2 bolts and intake duct.
5. REMOVE FRONT ACTIVE STABILIZER CONTROL ECU
a. Remove the 2 bolts and disconnect the 2 ground wires.
b. Disconnect the wire harness clamp from the bracket.
c. Using the procedures below, disconnect the ECU connector.
1. Release the lever's lock. (*1)
2. Press the claw and move the lever in the direction of the arrow in the illustration. (*2)
3. Disconnect the ECU connector. (*3)
NOTE: When disconnecting the ECU connector, do not apply excessive force to the wire harness.
d. Remove the bolt and 2 nuts, and disconnect the ECU from the body.
e. Disconnect the ECU connector.
INSTALLATION