GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
2. INSTALL FRONT NO. 1 STABILIZER BAR BUSH
(a)
Install the 2 bushes outside of the bush stoppers on the front stabilizer bar as shown in the illustration.
NOTICE:
Be sure to install the bushes so that the cutouts face the front of the vehicle.
3. INSTALL FRONT NO. 1 STABILIZER BRACKET LH
(a)
Press the front stabilizer bracket No. 1 LH against the frame and away from the vehicle. Then temporarily install bolt A.
(b) Install bolt B. Then tighten bolt A, and install bolts C and D.
Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
(c)
Install the clamp of the skid control sensor wire to the front stabilizer bracket No. 1 LH.
4. INSTALL FRONT NO. 1 STABILIZER BRACKET RH
HINT:
Install the RH side following the same procedures as the LH side.
5. INSTALL FRONT NO. 2 STABILIZER BRACKET LH
(a)
Install the bracket on the vehicle with the 2 bolts.
Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf)
6. INSTALL FRONT NO. 2 STABILIZER BRACKET RH
HINT:
Install the RH side following the same procedures as the LH side.