GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
(h) Adjust the rear suspension support to the installation position of the lower part of the rear shock absorber so that the studs are positioned as
shown in the illustration.
NOTICE:
Make sure that the left coil spring end faces toward the front of the vehicle and the right coil spring end faces toward the rear.
(i)
Release the SST and remove it from the rear coil spring.
NOTICE:
^
Do not an impact wrench. It will damage SST.
^
Remove the SST after confirming the position of the rear suspension support assembly.
INSTALLATION
1. INSTALL REAR SHOCK ABSORBER WITH COIL SPRING
(a)
Temporarily install the rear shock absorber with rear coil spring with the 2 bolts.
(b) Install the 3 nuts on the upper side of the rear shock absorber with coil spring.