GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
3. INSTALL SHOCK ABSORBER CAP UPPER (for AVS)
(a)
Connect the connector.
(b) Install the front shock absorber cap upper with the 3 nuts.
Torque: 20 N*m (202 kgf*cm, 15 ft.*lbf)
4. CONNECT FRONT SUSPENSION UPPER ARM
(a)
Connect the steering knuckle to the front suspension upper arm, and tighten it with the castle nut.
Torque: 87 N*m (887 kgf*cm, 64 ft.*lbf)
(b) Install a new clip to the steering knuckle.
NOTICE:
Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.
5. CONNECT FRONT SPEED SENSOR
(a)
Connect the front speed sensor to the front shock absorber with coil spring with the bolt.
Torque: 6.0 N*m (61 kgf*cm, 4.4 in.*lbf)
NOTICE:
^
Do not twist the front speed sensor while installing.
^
Be careful not to deform the bracket of the front shock absorber with coil spring when installing the bolt.