GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
_hybrid/Page-1579002.png)
a. Check that the control rod of the rear shock absorber is in the position shown in the illustration.
NOTE: If the control rod is not in the position shown in the illustration, turn the control rod to adjust the position and install the absorber
control actuator.
b. Install the absorber control actuator to the actuator support bracket. Turn the actuator clockwise approximately 40° until a click is felt.
NOTE: Do not excessively turn the actuator.
2. INSTALL REAR SHOCK ABSORBER CAP
a. Connect the connector and install the shock absorber cap.
3. INSTALL LUGGAGE COMPARTMENT TRIM COVER INNER LH
4. INSTALL LUGGAGE COMPARTMENT TRIM COVER FRONT
5. INSTALL REAR FLOOR FINISH PLATE
6. INSTALL TOOL BOX
7. INSTALL LUGGAGE COMPARTMENT TRIM COVER SIDE RH
8. INSTALL LUGGAGE COMPARTMENT TRIM COVER SIDE LH
9. INSTALL LUGGAGE COMPARTMENT FLOOR MAT
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
11. PERFORM INITIALIZATION
a. Perform initialization.
