GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
4. INSPECT REAR AXLE HUB BEARING LOOSENESS
(a)
Using a dial indicator, check for looseness near the center of the axle hub.
Maximum: 0.05 mm (0.0020 in.)
NOTICE:
Ensure that the dial indicator is set at a right angle to the measurement surface.
If the looseness exceeds the maximum, replace the axle hub.
5. INSPECT REAR AXLE HUB RUNOUT
(a)
Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.
Maximum: 0.05 mm (0.0020 in.)
NOTICE:
Ensure that the dial indicator is set at a right angle to the measurement surface.
If the runout exceeds the maximum, replace the axle hub.
6. INSTALL REAR DISC
7. CONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH
8. INSTALL REAR WHEEL
REMOVAL
CAUTION:
When the brake caliper is removed from the brake disc, do not start the hybrid system. If the hybrid system is started, the brake fluid
pressure may increase.
1. TURN POWER SWITCH OFF
(a)
Turn the power switch OFF, and check that the "READY" indicator turns off.
2. REMOVE REAR WHEEL
3. DISCONNECT LOAD SENSING VALVE SENSOR BRACKET