GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
3. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
(a)
Using SST, loosen the adjusting nut until it can be turned by hand.
SST 09922-10010
HINT:
Use 2 of the same SST.
(b) Put matchmarks on the transmission companion flange, flexible coupling and intermediate shaft.
(c)
Remove the 3 bolts, 3 washers and 3 nuts.
NOTICE:
The propeller shaft and flexible coupling should not be separated.
(d) Put matchmarks on the differential companion flange, flexible coupling and propeller shaft.
(e)
Remove the 3 bolts, 3 washers and 3 nuts.
NOTICE:
The propeller shaft and flexible coupling should not be separated.