GS 450h V6-3.5L (2GR-FSE) Hybrid (2007)
b. Using a brush, apply Primer M to the exposed part of the vehicle body.
NOTICE:
-
Allow the primer to dry for 3 minutes or more.
-
Do not apply primer to the adhesive.
-
Throw away any leftover primer.
-
Do not apply too much primer.
c. Using a brush or sponge, apply Primer G to the contact surface of the glass.
HINT: If the primer is applied to an area that is not specified, apply a non-residue solvent to a clean cloth and wipe off the excess primer.
NOTICE:
-
Allow the primer to dry for 3 minutes or more.
-
Throw away any leftover primer.
-
Do not apply too much primer.
d. Apply adhesive to the glass.
Adhesive: Part No. 08850-00801 or equivalent
1. Cut off the tip of the cartridge nozzle as shown in the illustration.
HINT: After cutting off the tip, use all adhesive within the time written in the table below.