HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
Rear Door Window Regulator: Service and Repair
Removal
WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Rear Door): REMOVAL
HINT
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
1. PRECAUTION (w/ Navigation System)
NOTICE:
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL See: Starting and Charging/Battery/Service and Repair/Removal
3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG See: Service and Repair/Overhaul/Disassembly
4. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL See: Service
and Repair/Overhaul/Disassembly
5. REMOVE REAR DOOR ARMREST COVER See: Service and Repair/Overhaul/Disassembly
6. REMOVE NO. 1 REAR DOOR STIFFENER CUSHION See: Service and Repair/Overhaul/Disassembly
7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY See: Service and Repair/Overhaul/Disassembly
8. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP See: Service and Repair/Overhaul/Disassembly
9. REMOVE REAR DOOR ARMREST SET BRACKET See: Service and Repair/Overhaul/Disassembly
10. REMOVE REAR DOOR SERVICE HOLE COVER See: Service and Repair/Overhaul/Disassembly
11. REMOVE REAR DOOR GLASS RUN See: Service and Repair/Overhaul/Disassembly
12. REMOVE NO. 2 REAR DOOR VENT SEAL See: Service and Repair/Overhaul/Disassembly
13. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY See: Service and Repair/Overhaul/Disassembly
14. REMOVE REAR DOOR QUARTER WINDOW GLASS See: Service and Repair/Overhaul/Disassembly
15. REMOVE REAR DOOR GLASS SUB-ASSEMBLY See: Service and Repair/Overhaul/Disassembly
16. REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY See: Service and Repair/Overhaul/Disassembly
17. REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY
(a) Using a T25 "TORX" driver, remove the 3 screws and the rear power window regulator motor assembly.