HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
NOTICE:
Do not apply positive (+) battery voltage to any terminals other than terminal 2 (B) to avoid damaging the pulse sensor inside the
motor.
(b) Connect a ground lead to connector terminals 1 (GND) and 7 (DOWN) or 10 (UP).
(c) Check that the motor gear rotates smoothly as follows:
OK:
Text in Illustration
*
If the result is not as specified, replace the rear power window regulator motor assembly LH.
CAUTION:
Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator
assembly onto the door.