HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
Hood Latch Release Cable: Service and Repair
Installation
DOOR / HATCH: HOOD LOCK CONTROL CABLE ASSEMBLY: INSTALLATION
1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY
(a) Pass the hood lock control cable assembly into the engine compartment.
(b) Pass the cable through the upper radiator support.
(c) Engage each clamp.
(d) Connect the hood lock control cable assembly.
2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
(a) Connect the hood lock control cable assembly to the hood lock control lever sub-assembly.
(b) Engage the claw and 2 guides to install the hood lock control lever sub-assembly.
3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL See: Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Upper Instrument Panel/Installation
4. INSTALL INSTRUMENT SIDE PANEL LH See: Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal and
Replacement/Upper Instrument Panel/Installation
5. INSTALL COWL SIDE TRIM BOARD LH See: Interior Moulding / Trim/Headliner/Service and Repair/Removal and Replacement/Installation
6. INSTALL FRONT DOOR OPENING TRIM COVER LH See: Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
7. INSTALL FRONT DOOR SCUFF PLATE LH See: Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
8. INSTALL FRONT FENDER LINER LH
HINT
Use the same procedure for the RH side and LH side See: Wiper and Washer Systems/Windshield Washer Motor/Service and
Repair/Installation.
9. INSTALL FRONT WHEEL LH
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
10. INSTALL COOL AIR INTAKE DUCT SEAL See: Bumper/Front Bumper/Service and Repair/Removal and Replacement/Installation