HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
HINT
Tape the screwdriver tip before use.
(b) Release the ball joint and remove the luggage compartment door support assembly.
NOTICE:
Remove the luggage compartment door support assembly while supporting the luggage compartment door by hand.
Installation
DOOR / HATCH: LUGGAGE COMPARTMENT DOOR SUPPORT: INSTALLATION
1. INSTALL LUGGAGE COMPARTMENT DOOR SUPPORT ASSEMBLY
NOTICE:
*
Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while
servicing.
*
Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas
leaks.
*
In order to prevent the piston rod from deforming, do not apply any horizontal load to the door support.
(a) When reusing the luggage compartment door support assembly:
(1) Install the 2 stop rings to the luggage compartment door support assembly.
(b) Install the luggage compartment door support assembly.
NOTICE:
*
Install the luggage compartment door support assembly while supporting the luggage compartment door by hand.
*
Check that the luggage compartment door support assembly is engaged in the ball joint and that the luggage compartment door
support assembly cannot be pulled out.
2. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER See: Lighting and Horns/Backup Lamp/Service and Repair/Removal and
Replacement/Installation
3. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY See: Lighting and Horns/Trunk Lamp/Service and Repair/Installation
4. INSTALL LUGGAGE COMPARTMENT FLOOR MAT See: Starting and Charging/Battery/Service and Repair/Installation