HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
*
Since a stopper nut is used, turn the bolt.
*
Do not remove the bolt.
(c) Remove the bolt (B) and nut, and then slowly lower the rear No. 2 suspension arm assembly LH, and remove the rear coil spring LH.
NOTICE:
Since a stopper nut is used, turn the bolt.
(d) Remove the bolt, nut and rear No. 2 suspension arm assembly LH from the rear suspension member sub-assembly.
NOTICE:
Since a stopper nut is used, turn the bolt.
27. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY RH
HINT
Perform the same procedure as the LH side.
28. REMOVE REAR UPPER COIL SPRING INSULATOR LH See: Steering and Suspension/Suspension/Suspension Spring ( Coil / Leaf )/Service
and Repair/Removal
29. REMOVE REAR UPPER COIL SPRING INSULATOR RH
HINT
Perform the same procedure as the LH side.
30. REMOVE REAR LOWER COIL SPRING INSULATOR LH See: Steering and Suspension/Suspension/Suspension Spring ( Coil / Leaf
)/Service and Repair/Removal
31. REMOVE REAR LOWER COIL SPRING INSULATOR RH
HINT
Perform the same procedure as the LH side.
32. REMOVE REAR STABILIZER BAR See: Steering and Suspension/Suspension/Stabilizer Bar/Service and Repair/Rear Stabilizer Bar/Removal
33. REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY
(a) Support the rear suspension member sub-assembly with a jack using 4 wooden blocks or equivalent tools as shown in the illustration.
Text in Illustration
NOTICE:
Make sure to secure the rear suspension member sub-assembly to prevent it from dropping.
(b) Remove the 2 bolts, 2 rear suspension member rear lower stoppers, 2 nuts (A), 2 nuts (B) and 2 rear suspension member lower stoppers.