HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
Acceleration/Deceleration Sensor: Service and Repair
Removal
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: YAW RATE AND ACCELERATION SENSOR: REMOVAL
NOTICE:
While the battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or
any door courtesy switch is turned on. Therefore, when servicing the brake system components, do not depress the brake pedal or
open/close the doors while the battery is connected.
1. REMOVE COOLER BLOWER ASSEMBLY (for Rear Side)
HINT
Refer to the procedure up to Remove Cooler Blower Assembly See: Heating and Air Conditioning/Blower Motor/Service and
Repair/Removal and Replacement/Blower Unit (for Rear Side)/Removal.
2. REMOVE YAW RATE AND ACCELERATION SENSOR
(a) Remove the 2 bolts and yaw rate and acceleration sensor from the body.
(b) Disconnect the yaw rate and acceleration sensor connector from the yaw rate and acceleration sensor.