HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
*
Use the same procedure for the LH side and RH side.
*
The following procedure is for the LH side.
*
If the sensor rotor needs to be replaced, replace it together with the front axle hub and bearing assembly.
1. REMOVE LUGGAGE COMPARTMENT FLOOR MAT See: Starting and Charging/Battery/Service and Repair/Removal
2. PRECAUTION (w/ Navigation System)
NOTICE:
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL See: Starting and Charging/Battery/Service and Repair/Removal
4. REMOVE FRONT WHEEL
5. REMOVE FRONT FENDER LINER
(a) Remove the 9 clips, 10 screws, 3 grommets, bolt and front fender liner.
HINT
Use the same procedure for the LH side and RH side.
6. REMOVE FRONT SPEED SENSOR
(a) Remove the 2 front speed sensor wire harness clamps and disconnect the front speed sensor connector.
(b) Remove the bolt and No. 2 sensor clamp from the body.
Text in Illustration
(c) Remove the bolt, No. 1 sensor clamp and front brake flexible hose together from the front shock absorber assembly.
Text in Illustration