HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
HINT
*
The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor malfunctions, replace the
rear axle hub and bearing assembly.
*
If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.
2. INSPECT REAR AXLE HUB BEARING LOOSENESS See: Maintenance/Wheels and Tires/Wheel Hub/Testing and Inspection/Rear Axle Hub
3. INSPECT REAR AXLE HUB RUNOUT See: Maintenance/Wheels and Tires/Wheel Hub/Testing and Inspection/Rear Axle Hub
4. INSTALL REAR DISC See: Disc Brake System/Service and Repair/Removal and Replacement/Rear Brake/Installation
5. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY See: Maintenance/Wheels and Tires/Wheel Hub/Service and Repair/Rear Axle
Hub/Installation
6. CONNECT REAR SPEED SENSOR WIRE
(a) Connect the rear speed sensor wire connector to the rear speed sensor.
7. INSTALL REAR SUSPENSION ARM COVER See: Steering and Suspension/Suspension/Control Arm/Service and Repair/Rear Lower
Arm/Installation
8. ADJUST PARKING BRAKE SHOE CLEARANCE AND PARKING BRAKE PEDAL TRAVEL See: Parking Brake System/Adjustments
9. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG See: Disc Brake System/Service and Repair/Removal and Replacement/Rear
Brake/Installation
10. INSTALL REAR WHEEL
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL See: Starting and Charging/Battery/Service and Repair/Installation
12. INSTALL LUGGAGE COMPARTMENT FLOOR MAT See: Starting and Charging/Battery/Service and Repair/Installation
13. CHECK FOR SPEED SENSOR SIGNAL
See: Testing and Inspection/Scan Tool Testing and Procedures/Test Mode Procedure