HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
_hybrid/Page-1646002.png)
(a) Install the brake booster pump assembly with bracket with the 3 nuts.
Torque : 19 Nm (194 kgf-cm, 14 ft-lbf)
NOTICE:
*
Do not kink or damage the brake lines, fuel lines or wire harness.
*
Tighten the 3 nuts in the order shown in the illustration.
(b) Engage the 2 clamps and install the bolt.
Torque : 7.0 Nm (71 kgf-cm, 62 in-lbf)
NOTICE:
Do not kink or damage the brake lines, fuel lines or wire harness.
(c) Using a union nut wrench, connect the front No. 1 brake line to the brake booster pump assembly.
Text in Illustration
NOTICE:
*
Do not kink or damage the brake lines.
*
Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench
See: Service Precautions.
(d) Install the No. 6 brake tube clamp with the bolt.
Torque : 7.0 Nm (71 kgf-cm, 62 in-lbf)
(e) Engage the clamp and connect the 2 connectors.
(f) Install the wire harness clamp bracket with the bolt and nut.
