HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
_hybrid/Page-1650004.png)
NOTICE:
*
Make sure to match the identification marks on the hoses and brake booster with master cylinder assembly.
*
When connecting the reservoir hose, face the identification mark to the top of the vehicle.
*
Make sure to install the hose to the proper location.
*
Install the clip within the range shown in the illustration.
10. CONNECT NO. 2 RESERVOIR HOSE
11. INSTALL BRAKE MASTER CYLINDER RESERVOIR WITH BRACKET
(a) Install the brake master cylinder reservoir with bracket with the 2 nuts.
Torque : 50 Nm (510 kgf-cm, 37 ft-lbf)
12. INSTALL AIR CLEANER CASE See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation
13. INSTALL AIR CLEANER CAP SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Installation
14. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Installation
15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL See: Starting and Charging/Battery/Service and Repair/Installation
16. INSTALL LUGGAGE COMPARTMENT FLOOR MAT See: Starting and Charging/Battery/Service and Repair/Installation
17. BLEED BRAKE SYSTEM See: Brake Bleeding/Service and Repair
18. INSPECT AND ADJUST BRAKE PEDAL
HINT
See: Brake Pedal Assy/Adjustments
19. OBTAIN ZERO POINT OF YAW RATE AND ACCELERATION SENSOR
HINT
After the brake booster with master cylinder assembly is replaced, obtain the zero point of the yaw rate and acceleration sensor See:
Antilock Brakes / Traction Control Systems/Testing and Inspection/Programming and Relearning/Calibration.
20. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Lower Instrument Panel/Installation
21. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY
(a) Install the outer cowl top panel sub-assembly with the 9 bolts.
