HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
Variable Valve Timing Actuator: Service and Repair
Installation
2AZ-FXE ENGINE CONTROL: CAMSHAFT OIL CONTROL VALVE: INSTALLATION
1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
(a) Apply a light coat of engine oil to a new O-ring and install it onto the camshaft timing oil control valve assembly.
Text in Illustration
NOTICE:
Do not twist the O-ring.
(b) Install the camshaft timing oil control valve assembly with the bolt.
Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)
(c) Connect the camshaft timing oil control valve assembly connector.
2. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY See: Service and Repair/Removal and Replacement/Engine Assembly/Installation
3. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY See: Brakes and Traction Control/Power Brake Assist/Vacuum Brake
Booster/Service and Repair/Installation
4. INSTALL COWL BODY MOUNTING REINFORCEMENT RH See: Brakes and Traction Control/Power Brake Assist/Vacuum Brake
Booster/Service and Repair/Installation
5. INSTALL NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL See: Brakes and Traction Control/Power Brake Assist/Vacuum Brake
Booster/Service and Repair/Installation
6. INSTALL WATER GUARD PLATE RH See: Brakes and Traction Control/Power Brake Assist/Vacuum Brake Booster/Service and
Repair/Installation
7. INSTALL FRONT WIPER MOTOR AND LINK
(a) Install the front wiper motor and link See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Installation.