HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
Drive Belt: Service and Repair
Removal
2AZ-FXE ENGINE MECHANICAL: DRIVE BELT: REMOVAL
1. REMOVE FRONT WHEEL RH
2. REMOVE REAR ENGINE UNDER COVER RH
3. REMOVE COOL AIR INTAKE DUCT SEAL See: Service and Repair/Removal and Replacement/Engine Assembly/Removal
4. REMOVE V-RIBBED BELT TENSIONER COVER SUB-ASSEMBLY
(a) Remove the 2 bolts and V-ribbed belt tensioner cover sub-assembly.
5. REMOVE V-RIBBED BELT
(a) Loosen the V-ribbed belt tensioner counterclockwise, then remove the V-ribbed belt.
NOTICE:
*
When retracting the tensioner, turn it clockwise slowly. Do not apply force rapidly.
*
After the tensioner is fully retracted, do not apply force more than necessary.