HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
_hybrid/Page-2076018.png)
(a) Install the rear No. 1 heater register bezel with the 2 screws.
(b) Engage the 4 claws.
25. INSTALL REAR NO. 1 HEATER REGISTER BEZEL (for RH Side)
HINT
Use the same procedure for the RH side and LH side.
26. CONNECT INLET HEATER WATER HOSE
(a) Using pliers, grip the claws of the clip and slide the clip to connect the inlet heater water hose.
27. CONNECT OUTLET HEATER WATER HOSE
(a) Using pliers, grip the claws of the clip and slide the clip to connect the outlet heater water hose.
28. CONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY
(a) Remove the attached vinyl tape from the pipe.
(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the air conditioning tube and accessory assembly.
Compressor oil:
ND-OIL 11 or equivalent
NOTICE:
*
Keep the O-ring and O-ring fitting surfaces clean from dirt or any foreign objects.
*
Do not use any compressor oil other than ND-OIL 11 or equivalent. If any compressor oil other than ND-OIL 11 or equivalent is
used, compressor motor insulation performance may decrease, resulting in a leakage of electric power.
(c) Install the O-ring on the air conditioning tube and accessory assembly.
(d) Install the air conditioning tube and accessory assembly.
29. CONNECT SUCTION PIPE SUB-ASSEMBLY
(a) Remove the attached vinyl tape from the pipe.
(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the suction pipe sub-assembly.
Compressor oil:
ND-OIL 11 or equivalent
(c) Install the O-ring on the suction pipe sub-assembly.
NOTICE:
*
Keep the O-ring and O-ring fitting surfaces clean from dirt or any foreign objects.
*
Do not use any compressor oil other than ND-OIL 11 or equivalent. If any compressor oil other than ND-OIL 11 or equivalent is
used, compressor motor insulation performance may decrease, resulting in a leakage of electric power.
(d) Install the suction pipe sub-assembly.
(e) Move the hook connector in the direction indicated by the arrow in the illustration.
(f) Insert the pipe joint into the fitting hole securely and tighten the bolt.
