HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)
NOTICE:
*
Make sure that the ends of the frame wire do not cross over each other.
*
Be sure to connect the frame wire to each correct terminal shown in the illustration.
(b) Install the battery shield contact.
NOTICE:
Be sure to install the battery shield contact in the correct direction.
4. INSTALL NO. 5 HYBRID BATTERY INTAKE DUCT
(a) Install the No. 5 HV battery intake duct.
NOTICE:
Ensure that the duct is installed securely.
5. CHECK HIGH VOLTAGE CABLE CONNECTION CONDITION
CAUTION:
Wear insulated gloves.
(a) Check that each wire harness is installed securely.
Text in Illustration
NOTICE:
*
Make sure that the ends of the frame wire do not cross over each other.
*
Be sure to connect the frame wire to the correct terminals shown in the illustration.
*
The connectors should be connected securely.
*
The nuts should be fastened securely.
6. INSTALL NO. 1 HYBRID BATTERY SHIELD SUB-ASSEMBLY
CAUTION:
Wear insulated gloves.
(a) Install the No. 1 hybrid battery shield sub-assembly with the 8 nuts.
Torque : 7.5 Nm (76 kgf-cm, 66 in-lbf)
(b) Install the battery cover lock striker, then push the button to lock it.