HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
Removal
HYBRID / BATTERY CONTROL: INVERTER WITH CONVERTER: REMOVAL
1. PRECAUTION
HINT
See: Service Precautions.
2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT See: Starting and Charging/Battery/Service and Repair/Removal
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL See: Starting and Charging/Battery/Service and Repair/Removal
4. REMOVE BATTERY SERVICE HOLE COVER See: Battery System, Hybrid Drive/Hybrid Battery Service Switch/Service and
Repair/Removal
5. REMOVE SERVICE PLUG GRIP See: Battery System, Hybrid Drive/Hybrid Battery Service Switch/Service and Repair/Removal
6. REMOVE NO. 1 ENGINE UNDER COVER
7. DRAIN COOLANT (for Inverter) See: Engine, Cooling and Exhaust/Cooling System/Coolant/Service and Repair/Coolant (For Inverter)
8. REMOVE COOL AIR INTAKE DUCT SEAL See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
9. REMOVE CONNECTOR COVER ASSEMBLY
CAUTION:
*
Do not touch the high voltage connectors and terminals for 10 minutes after the service plug grip is removed.
*
Wear insulated gloves.
NOTICE:
Do not start the hybrid system with the service plug grip removed because it may cause a malfunction.
(a) Remove the 2 bolts and connector cover assembly.