HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
Drive Motor Control Module: Service and Repair
Installation
HYBRID / BATTERY CONTROL: HYBRID VEHICLE CONTROL ECU: INSTALLATION
1. INSTALL HYBRID VEHICLE CONTROL ECU
(a) Install the 2 ECM brackets with the 4 screws.
Torque : 3.0 Nm (31 kgf-cm, 27 in-lbf)
(b) Connect the clamp to the ECM bracket.
(c) Install the hybrid vehicle control ECU with the 2 bolts.
Torque : 13 Nm (130 kgf-cm, 9 ft-lbf)
(d) Connect the 2 connectors.
NOTICE:
*
Before connecting the connectors, make sure that dirt, water or other foreign matter is not present on the connecting parts of the
connectors.
*
The lever is securely engaged.
*
The connector does not come out when its body is pulled.
2. INSTALL AIR CLEANER CASE See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation
3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Installation
4. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Installation
5. INSTALL COWL TOP PANEL OUTER SUB-ASSEMBLY
HINT
See: Brakes and Traction Control/Power Brake Assist/Vacuum Brake Booster/Service and Repair/Installation.
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL See: Starting and Charging/Battery/Service and Repair/Installation
7. INSTALL LUGGAGE COMPARTMENT FLOOR MAT See: Starting and Charging/Battery/Service and Repair/Installation
8. PERFORM INITIALIZATION
HINT
See: Testing and Inspection/Programming and Relearning.