HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
Headlamp Alignment Sensor: Service and Repair
Removal
LIGHTING (EXT): HEIGHT CONTROL SENSOR: REMOVAL
1. PRECAUTION (w/ Navigation System)
NOTICE:
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT See: Starting and Charging/Battery/Service and Repair/Removal
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL See: Starting and Charging/Battery/Service and Repair/Removal
4. REMOVE REAR WHEEL
5. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY
(a) Disconnect the connector.
(b) Disengage the clamp.
Text in Illustration
(c) Remove the 2 bolts.
(d) Disengage the 2 guides and remove the rear height control sensor sub-assembly.
NOTICE:
Do not drop the rear height control sensor sub-assembly. If it is dropped, replace it with a new one.