HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (NAVIGATION ECU)
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK -- REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY (NAVIGATION ECU) See: Accessories and Optional
Equipment/Navigation System/Navigation Display/Service and Repair/Removal and Replacement/Multi-Display/Removal
Power Management Control ECU Communication Stop Mode
NETWORKING: CAN COMMUNICATION SYSTEM: Power Management Control ECU Communication Stop Mode
- Power Management Control ECU Communication Stop Mode
DESCRIPTION
WIRING DIAGRAM