HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
(b) Measure the voltage and resistance according to the value(s) in the table below.
HINT
Measure the values on the wire harness side with the connector disconnected.
(b) If the result is not as specified, there may be a malfunction in the wire harness.
(c) Reconnect the K3 power window regulator motor assembly (for rear LH side) connector.
(d) Check for pulses according to the value(s) in the table below.
(d) If the result is not as specified, the power window regulator motor assembly (for rear LH side) may be malfunctioning.
6. CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
(a) Disconnect the I1 multiplex network master switch assembly connector.
(b) Measure the voltage and resistance according to the value(s) in the table below.
HINT
Measure the values on the wire harness side with the connector disconnected.
(b) If the result is not as specified, there may be a malfunction in the wire harness.
(c) Reconnect the I1 multiplex network master switch assembly connector.
(d) Check for pulses according to the value(s) in the table below.
(d) If the result is not as specified, the multiplex network master switch assembly may be malfunctioning.
7. CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)