HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
(h) Remove the instrument panel junction block assembly.
4. REMOVE MAIN BODY ECU
(a) Press the claw of the junction block as shown in the illustration to release the lock.
Text in Illustration
(b) With the junction block lock released, insert a screwdriver with its tip wrapped with protective tape horizontally between the main body ECU
and junction block.
NOTICE:
Use a screwdriver with a radius of between 5.0 mm (0.197 in.) and 6.3 mm (0.248 in.) and a length of approximately 90 mm (3.54 in.).
(c) Using the screwdriver, carefully raise the main body ECU up to the position where the connector becomes disengaged.
Text in Illustration
NOTICE:
Do not twist the screwdriver to raise the main body ECU.
(d) Raise the main body ECU as shown by the arrow (1), and then pull it out as shown by the arrow (2) shown in the illustration.
NOTICE:
Do not touch the ECU connector.