HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
Steering Column Control Module: Service and Repair
Installation
STEERING COLUMN: MULTIPLEX TILT AND TELESCOPIC ECU: INSTALLATION
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system
before servicing See: Restraint Systems/Air Bag Systems/Service Precautions.
1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU
(a) Install the multiplex tilt and telescopic ECU to the steering column assembly with the nut.
Torque : 25 Nm (255 kgf-cm, 18 ft-lbf)
(b) Connect the 2 connectors to the multiplex tilt and telescopic ECU.
(c) Engage the wire harness clamp to the multiplex tilt and telescopic ECU.
2. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
HINT
Refer to the instructions for Installation of the driver side knee airbag assembly See: Restraint Systems/Air Bag Systems/Air
Bag/Service and Repair/Removal and Replacement/Knee Airbag Assembly (for Driver Side)/Installation.
3. INSTALL LOWER STEERING COLUMN COVER See: Steering and Suspension/Steering/Steering Column/Service and Repair/Steering
Column Assembly (for Power Tilt and Power Telescopic Steering Column)/Installation
4. INSTALL LOWER NO. 2 STEERING COLUMN COVER See: Steering and Suspension/Steering/Steering Column/Service and Repair/Steering
Column Assembly (for Power Tilt and Power Telescopic Steering Column)/Installation
5. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
6. ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral
Cable/Service and Repair/Installation
7. INSTALL STEERING WHEEL ASSEMBLY See: Steering and Suspension/Steering/Steering Wheel/Service and Repair/Installation
8. INSTALL STEERING PAD
HINT
Refer to the instructions for Installation of the steering pad See: Restraint Systems/Air Bag Systems/Air Bag/Service and
Repair/Removal and Replacement/Steering Pad/Installation.