HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
(2) Disassemble the front seat assembly See: Body and Frame/Seats/Service and Repair/Overhaul/Front Seat Assembly/Disassembly.
(3) Remove the 2 nuts, clamps and front seat side airbag assembly from the front seatback assembly.
CAUTION:
When storing the front seat side airbag assembly, keep the airbag deployment side facing upward.
(c) Using braided wire, tie down the front seat side airbag assembly to an unneeded tire.
Text in Illustration
Wire:
Stripped wire section
1.25 mm2 (0.0019 in.2) or more
CAUTION:
If the wire is too thin or an alternative object is used to tie down the front seat side airbag assembly, it may snap when the airbag is
deployed. Always use a wire for vehicle use with an area of at least 1.25 mm2 (0.0019 in.2).
HINT
To calculate the area of the stripped wire section:
Area = 3.14 x (Diameter)2 / 4
(1) Install the 2 nuts to the front seat side airbag assembly.
(2) Wind the wires around the stud bolts of the front seat side airbag assembly as shown in the illustration.
(3) Position the front seat side airbag assembly inside the tire.