HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
(b) Remove the 2 bolts.
(c) Disengage the guide and remove the rear seat 3 point type belt assembly.
Installation
SEAT BELT: REAR SEAT OUTER BELT ASSEMBLY: INSTALLATION
1. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY
(a) Engage the guide.
(b) Fully tighten the bolt (A) first, then the bolt (B) to install the front seat outer belt assembly.
Bolt A - Torque : 7.5 Nm (77 kgf-cm, 66 in-lbf)
Bolt B - Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)
(c) Connect the connector.
(d) Check if the ELR locks.
NOTICE:
The check should be performed with the rear seat 3 point type belt assembly installed.
(1) With the belt assembly installed, check that the belt locks when it is pulled out quickly.
2. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/o Rear Sunshade)
(a) Engage the 5 guides as shown in the illustration.
(b) Engage the 3 clips to install the package tray trim panel assembly.
3. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade) See: Windows and Glass/Windows/Window Shade/Service and
Repair/Installation
4. INSTALL CENTER STOP LIGHT SET (w/o Rear Sunshade) See: Lighting and Horns/Center Mounted Brake Lamp/Service and
Repair/Installation
5. INSTALL REAR SEAT SHOULDER BELT COVER
(a) Engage the 4 claws to install the rear seat shoulder cover.