HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
Text in Illustration
SST : 09961-00950
without SST - Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)
with SST - Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
NOTICE:
*
Do not depress the brake pedal after turning the power switch on (IG).
*
Use a torque wrench with a fulcrum length of 185 mm (7.28 in.).
*
This torque value is effective when SST is parallel to the torque wrench.
(8) Turn the power switch off.
(9) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
w/ navigation system:
After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
(10) Disconnect the Techstream.
4. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
HINT
Refer to the procedure from Install Driver Side Knee Airbag Assembly See: Restraint Systems/Air Bag Systems/Air Bag/Service and
Repair/Removal and Replacement/Knee Airbag Assembly (for Driver Side)/Installation.
5. CHECK FOR AND CLEAR DTC
(a) Check for and clear the DTCs See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Reading
and Clearing Diagnostic Trouble Codes.
6. PERFORM LINEAR VALVE OFFSET LEARNING
(a) Perform linear valve offset learning See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and
Inspection/Programming and Relearning/Initialization.