HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
Rain Sensor: Service and Repair
Removal
WIPER / WASHER: RAIN SENSOR: REMOVAL
1. REMOVE RAIN SENSOR COVER
(a) Disengage the 2 guides and disconnect the rain sensor cover as shown in the illustration.
(b) Disengage the 2 claws and remove the rain sensor cover.
2. REMOVE RAIN SENSOR
(a) Disconnect the connector.
(b) Release the stopper by pulling the stopper down and disconnect the rain sensor as shown in the illustration.
Text in Illustration
3. CLEAN WINDSHIELD GLASS
HINT
*
Rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated.
*
Check that the rain sensor tape does not remain on the windshield glass. If it does, remove it before installing the rain sensor.