HS 250h L4-2.4L (2AZ-FXE) Hybrid (2010)
Text in Illustration
(b) Remove the tie rod end sub-assembly LH and lock nut.
28. REMOVE TIE ROD END SUB-ASSEMBLY RH
HINT
Perform the same procedure as for the LH side.
Installation
STEERING GEAR / LINKAGE: STEERING GEAR: INSTALLATION
1. INSTALL TIE ROD END SUB-ASSEMBLY LH
(a) Install the lock nut and tie rod end sub-assembly LH to the steering gear assembly until the matchmarks are aligned.
Text in Illustration
HINT
After adjusting the toe-in, tighten the lock nut.
2. INSTALL TIE ROD END SUB-ASSEMBLY RH
HINT
Perform the same procedure as for the LH side.
3. INSTALL STEERING LINK ASSEMBLY
(a) Install the steering link assembly to the front suspension crossmember sub-assembly with the 2 bolts and 2 nuts.
NOTICE:
*
Keep the nut from rotating while turning the bolt because the nut has its own stopper.
*
Make sure to tighten the bolts starting from the left side of the vehicle.
Torque : 138 Nm (1407 kgf-cm, 102 ft-lbf)
4. INSTALL STEERING INTERMEDIATE SHAFT
(a) Align the matchmarks and install the steering intermediate shaft to the steering link assembly.